ট্রান্সমিশন এন্ড ডিস্ট্রিবিউশন অব ইলেক্ট্রিক্যাল পাওয়ার MCQ
41. ACSR means-
ব্যাখ্যা: ACSR = Aluminium conductor steel reinforced.
Aluminium core steel reinforced
Aluminium conductor steel reinforced
Aluminium copper steel reinforced
reinforced all conductor steel
42. Under over excitation synchronous phase modifier works as-
43. For flat voltage profile system, voltage regulation is-
44. The presence of earth in case of overhead lines-
ব্যাখ্যা: As the earth is considered to be an infinite source of electrons, the presence of overhead lines causes charge currier to be separated by a dielectric (air), causing an increase in capacitance.
45. Stability of a transmission line can be increased by—
46. Which of the following statement is true?
At higher voltage, cost of transmission is reduced
At higher voltage, cost transmission is increased
47. Which of the following methods is/are used for reactive or voltage compensation?
generation excitation control
48. Under excited synchronous phase modifier works as-
49. Advantages of higher trans mission voltage is/are--
Power transfer capability of the transmission line is increased
Transmission line losses are reduced
Area of cross section and volume of the conductor is reduced
50. The main objectives of electrical power transmission is/are-
Transmission system must be more efficient with minimum line losses
Voltage regulation of the transmission line must be zero or minimum
51. Ferranti effect can be compensated by which of the following?
52. The charging reactance of 50km transmission line is 1500Ω. What is the charging reactance for 100km length of line?
53. Galvanised steel is generally used as--
54. The skin effect of conductor will increase when-
55. Maximum power transfer capability of transmission line can be increased by-
Parallel transmission lines
56. Ferranti effect will not occur in which of the following transmission lines-
medium transmission lines
57. Which of the following method is used for changing power factor from leading to lagging?
58. If sparsity of a 5 bus transmission line is 0.4. Find the number of transmission lines--
59. Surge impedance loading of a 3-phase, 400k Y transmission line is 4002. The surge impedance loading is-
60. Maximum power transfer in a transmission line can be obtained by—
Showing
41
to
60
of
412
results
Test Mode
Reading Mode